Prevent that users try to boot a 64-bit only C3700 machine with a 32-bit
CPU, and to boot a 32-bit only B160L machine with a 64-bit CPU.
Signed-off-by: Helge Deller <deller@gmx.de>
The CPU HPA is in the high F-region on PA2.0 CPUs, so use F_EXTEND()
to trigger interrupt request at the right CPU HPA address.
Note that the cpu_hpa value comes out of the IRT, which doesn't store the
higher addresss bits.
Signed-off-by: Helge Deller <deller@gmx.de>
Fill in the insn_start value during form_gva, and copy
it out to the env field in hppa_restore_state_to_opc.
The value is not yet consumed.
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
The previous decoding misnamed the bit it called "local".
Other than the name, the implementation was correct for pa1.x.
Rename this field to "tlbe".
PA2.0 adds (a real) local bit to PxTLB, and also adds a range
of pages to flush in GR[b].
Signed-off-by: Helge Deller <deller@gmx.de>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
These are aliased onto the normal integer loads to %g0.
Since we don't emulate caches, prefetch is a nop.
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Hack the machine to use pa2.0 physical layout when required,
using the PSW.W=0 absolute to physical mapping.
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
There's nothing about elf that specifically requires signed vs unsigned.
This is very much a target-specific preference.
In the meantime, casting low and high from uint64_t back to Elf_SWord
to uint64_t discards high bits that might have been set by translate_fn.
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Reduce the number of times we look for the constant 0.
Reviewed-by: Philippe Mathieu-Daudé <philmd@linaro.org>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
The default PSW is set by the operating system with the PDC_PSW
firmware call. Use that setting to decide if wide mode is to be
enabled for interruptions and EIRR usage.
Signed-off-by: Helge Deller <deller@gmx.de>
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Split out the tlb to a subsection so that it can be separately
versioned -- the format is only partially following the architecture
and is partially guided by the qemu implementation.
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
The conversions to/from i64 can be eliminated entirely,
folding computation into adjacent operations.
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
The size of target_ureg is going to change.
Reviewed-by: Philippe Mathieu-Daudé <philmd@linaro.org>
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Rename the existing insert tlb helpers to emphasize that they
are for pa1.1 cpus. Implement a combined i/d tlb for pa2.0.
Still missing is the new 'P' tlb bit.
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Allow both user-only and system mode to run pa2.0 cpus.
Avoid creating a separate qemu-system-hppa64 binary;
force the qemu-hppa binary to use TARGET_ABI32.
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
There is no support for hppa64 in gdb. Any attempt to provide the
data for the larger hppa64 registers results in an error from gdb.
Mask CR_SAR writes to the width of the register: 5 or 6 bits.
Signed-off-by: Richard Henderson <richard.henderson@linaro.org>
Helge Deller