-Disabled Intellicart hook for ReadMemory, which seemed to be interfering.
-Implemented MVO@.
-Several instructions are now executed in succession until it hits the unimplemented "XORR R5, R5".
I should probably refactor Disassemble and Execute to label registers as source / destination to avoid further confusion at some point. My disassembly might have the source / destination registers flipped as well.
-Fixed disassembly for JMP:
--Now it uses the parameter pc, not RegisterPC.
--I was loading both the second and third value from the second's address.
--Casting the calculated addresses to bytes when addresses are 16-bit was a bad idea.
--Removed a closing parenthesis I accidentally stuck in the formatting.
It seems that I've gotten far enough to use the Executive ROM as a test case! Now to go instruction by instruction and see if they work as planned and hope this will all eventually make something.
--Afterwards, the data is reconciled, right now by chucking out the core value if the cart responded.
-WriteMemory now writes to both the core and the cart unconditionally.
--Each case now breaks out of the switch statement in case we want to do more complex things at the end of the function later on.
-All default paths in both functions now throw an exception.
-Implemented the final CRC check.
I didn't get around to implementing bank-switched ranges, but I don't think it's worth worrying about that right now considering that the Intellicart is not marked as readable at the initial PC, so something is either wrong or I need to implement more things before this will work. I think I'll put Intellicarts on hold and try to get a .int / .bin to run in the meantime.
--In my test case, only a few segments were set to readable and nothing else was set. 0x1000, which is where the PC is initialized to, certainly isn't in a writable page.
--Although I've read that these memory attributes affect the Intellivision and not the Intellicart, I'm pretty sure this has to be implemented in the Intellicart so that my Read/WriteCart functions can choose to respond / not respond depending on these attributes. I very well could be wrong.
-Hooked Read/WriteCart into Read/WriteMemory.
-Implemented memory attributes into Read/WriteCart.
--TODO: Bank-switching.
TODO: Fine address table and memory attribute / fine address checksums.
-Initialized the memory devices with a tentative size that ignores the unofficial ranges.
-Masked addresses to match those sizes (That's my understanding of what the memory map needs to do based on other examples).
-Added the ICart interface.
-Started the Intellicart parser; got far enough to know that the files I'm working with are not Intellicarts. ^_^
-Fixed JMP disassembly; I need to return on an invalid opcode because I was breaking out of the inner switch statement, not both that and the outer one.
-Set up the "official" memory map - see http://wiki.intellivision.us/index.php?title=Memory_Map
--Things I didn't do:
---Accessibility.
---Additional Occupied Memory Ranges.
---Addresses Available to Cartridges
---Initialize any of the byte arrays.
--Not sure which of these I need to do, but clearly the byte arrays have to be initialized somewhere to something and there's a lot of gaps in this memory map.
brandman211