mirror of https://github.com/xemu-project/xemu.git
9f9dcb96a4
The correct A20 masking is done if paging is enabled (protected mode) but it seems to have been forgotten in real mode. For example from the AMD64 APM Vol. 2 section 1.2.4: > If the sum of the segment base and effective address carries over into bit 20, > that bit can be optionally truncated to mimic the 20-bit address wrapping of the > 8086 processor by using the A20M# input signal to mask the A20 address bit. Most BIOSes will enable the A20 line on boot, but I found by disabling the A20 line afterwards, the correct wrapping wasn't taking place. `handle_mmu_fault' in target/i386/tcg/sysemu/excp_helper.c seems to be the culprit. In real mode, it fills the TLB with the raw unmasked address. However, for the protected mode, the `mmu_translate' function does the correct A20 masking. The fix then should be to just apply the A20 mask in the first branch of the if statement. Signed-off-by: Stephen Michael Jothen <sjothen@gmail.com> Message-Id: <Yo5MUMSz80jXtvt9@air-old.local> Signed-off-by: Paolo Bonzini <pbonzini@redhat.com> |
||
|---|---|---|
| .. | ||
| alpha | ||
| arm | ||
| avr | ||
| cris | ||
| hexagon | ||
| hppa | ||
| i386 | ||
| m68k | ||
| microblaze | ||
| mips | ||
| nios2 | ||
| openrisc | ||
| ppc | ||
| riscv | ||
| rx | ||
| s390x | ||
| sh4 | ||
| sparc | ||
| tricore | ||
| xtensa | ||
| Kconfig | ||
| meson.build | ||