Fixes some issues with opening ini/log files when the path contains
characters that are not present in the current codepage for the
following plugins:
SPU2-X
LilyPad
cdvdGigaherz
Dev9null
USBnull
FWnull
Avoid always setting the dialog to the centre of the screen - the GTK+3
documentation advises against it.
Avoid using a GUI callback - it's unnecessary since the value can just
be retrieved afterwards.
Simplify the GUI construction - a container to handle layout isn't
necessary due to the GUI's lack of complexity.
IOCTL_SCSI_PASS_THROUGH_DIRECT will return success even if the read
fails (I'm not sure when it'll return failure). Assume the read is
successful only when the read length is correct.
Avoid using the IOCTL_DVD_START_SESSION and IOCTL_DVD_END_SESSION ioctls
- it's not necessary to obtain an Authentication Grant ID (AGID) before
requesting the DVD physical format layer descriptor.
For some CDs (i.e. Suikoden), trying to read a 2048 byte "cooked" sector
does not work. However, reading the raw sector and then extracting the
required 2048 bytes works fine, so let's do that.
This also makes it easier to port CD/DVD disk reading to operating
systems that don't provide CD/DVD interface conveniences.
The wrong comparison was used, so all the relative offsets were
completely wrong. Fixes the wrong track issue in the CD player.
Regression introduced in f314c2a4d9.
Avoid reading past the end of the disk.
Avoid waiting when there are prefetches remaining.
Fix the maths so that the first prefetch after a request attempts to
read the next block of sectors and not the block of sectors that was
just read (which will just be skipped anyway because the data has just
been cached).
Avoid potential prefetch after disk is swapped (though disc swap doesn't
work properly if you just eject and insert a different disk).
Stop prefetching on disk read failure (Suikoden hits this case - 2048
byte reads are requested, but only 2352 byte reads will succeed).
Also reduce the read retry count to 2.
Fixes Coverity CID 127721: Program hangs
Change the sleep to a condition variable wait, which has the added
benefit of allowing the plugin to close ever so slightly faster if
there's no disc in the drive.
Also refactor the default drive selection and GUI code so optical drive
detection is shared.
Note: This breaks the current config, but there's only one setting
anyway.
Don't use a RAW_READ_INFO struct when only the LARGE_INTEGER member is
used. Use SetFilePointerEx which is slightly simpler and doesn't require
checking GetLastError() in some circumstances to check whether the read
has actually failed.
Also use a mutex to prevent simultaneous access from both the read
thread and the keepalive thread to prevent overlapping SetFilePointerEx
calls from causing the wrong data to be read.
And print error messages should a failure occur.
Also set the max drive speed to 4x DVD and 24xCD (down from 8x DVD and
36x CD) - it seems to reduce pausing slightly since the drive doesn't
require as much time to spin up to the desired speed.
Also set the disc speed at the correct time - CDROM SET SPEED only stays
in effect till the disc is removed.
Also fix a memleak in CDVDopen when the drive cannot be accessed.
Jonathan Li