Avoid reading past the end of the disk.
Avoid waiting when there are prefetches remaining.
Fix the maths so that the first prefetch after a request attempts to
read the next block of sectors and not the block of sectors that was
just read (which will just be skipped anyway because the data has just
been cached).
Avoid potential prefetch after disk is swapped (though disc swap doesn't
work properly if you just eject and insert a different disk).
Stop prefetching on disk read failure (Suikoden hits this case - 2048
byte reads are requested, but only 2352 byte reads will succeed).
Also reduce the read retry count to 2.
Fixes Coverity CID 127721: Program hangs
Change the sleep to a condition variable wait, which has the added
benefit of allowing the plugin to close ever so slightly faster if
there's no disc in the drive.
Also refactor the default drive selection and GUI code so optical drive
detection is shared.
Note: This breaks the current config, but there's only one setting
anyway.
Don't use a RAW_READ_INFO struct when only the LARGE_INTEGER member is
used. Use SetFilePointerEx which is slightly simpler and doesn't require
checking GetLastError() in some circumstances to check whether the read
has actually failed.
Also use a mutex to prevent simultaneous access from both the read
thread and the keepalive thread to prevent overlapping SetFilePointerEx
calls from causing the wrong data to be read.
And print error messages should a failure occur.
Also set the max drive speed to 4x DVD and 24xCD (down from 8x DVD and
36x CD) - it seems to reduce pausing slightly since the drive doesn't
require as much time to spin up to the desired speed.
Also set the disc speed at the correct time - CDROM SET SPEED only stays
in effect till the disc is removed.
Also fix a memleak in CDVDopen when the drive cannot be accessed.
It's rather unnecessary to use the same ioctls multiple times per disc
when the info returned doesn't change. Just use each ioctl once and
read/calculate all the necessary info all at onace.
This also fixes an issue where the IOCTL_DVD_START_SESSION ioctl is
repeatedly used if the returned session ID is 0. The previous code
assumed that 0 was not a valid session ID and would repeatedly use the
ioctl to obtain a non-zero session ID. However, 0 is a valid session ID,
and it seems IOCTL_DVD_START_SESSION can repeatedly return a 0 session
ID even if the corresponding IOCTL_DVD_END_SESSION has not been called.
In our case, a DVD session is only necessary for DVD detection and
reading the physical format information. This fix seems to alter drive
speed behaviour.
There doesn't seem to be any issues calling CreateFile with
GENERIC_WRITE access (which is necessary for SPTI) on a standard user
account, so the SPTI code should work in all cases.
A multi sector raw disk sector read that reads data from two tracks of
different types will not complete successfully. Reading the sectors one
at a time should fix the issue.
np511