byuu says:
Changelog:
- processor/spc700: restored fetch/load/store/pull/push shorthand
functions
- processor/spc700: split functions that tested the algorithm used (`op
!= &SPC700:...`) to separate instructions
- mostly for code clarity over code size: it was awkward having
cycle counts change based on a function parameter
- processor/spc700: implemented Overload's new findings on which
cycles are truly internal (no bus reads)
- sfc/smp: TEST register emulation has been vastly improved¹
¹: it turns out that TEST.d4,d5 is the external clock divider (used
when accessing RAM through the DSP), and TEST.d6,d7 is the internal
clock divider (used when accessing IPLROM, IO registers, or during idle
cycles.)
The DSP (24576khz) feeds its clock / 12 through to the SMP (2048khz).
The clock divider setting further divides the clock by 2, 4, 8, or 16.
Since 8 and 16 are not cleanly divislbe by 12, the SMP cycle count
glitches out and seems to take 10 and 2 clocks instead of 8 or 16. This
can on real hardware either cause the SMP to run very slowly, or more
likely, crash the SMP completely until reset.
What's even stranger is the timers aren't affected by this. They still
clock by 2, 4, 8, or 16.
Note that technically I could divide my own clock counters by 24 and
reduce these to {1,2,5,10} and {1,2,4,8}, I instead chose to divide by
12 to better illustrate this hardware issue and better model that the
SMP clock runs at 2048khz and not 1024khz.
Further, note that things aren't 100% perfect yet. This seems to throw
off some tests, such as blargg's `test_timer_speed`. I can't tell how
far off I am because blargg's test tragically doesn't print out fail
values. But you can see the improvements in that higan is now passing
all of Revenant's tests that were obviously completely wrong before.
byuu says:
Changelog:
- fc/controller: added ControllerPort class; removed Peripherals class
- md/controller/gamepad: removed X,Y,Z buttons since this isn't a
6-button controller
- ms/controller: added ControllerPort class (not used in Game Gear
mode); removed Peripherals class
- pce/controller: added ControllerPort class; removed Peripherals
class
- processor/spc700: idle(address) is part of SMP class again, contains
flag to detect mov (x)+ edge case
- sfc/controller/super-scope,justifier: use CPU frequency instead of
hard-coding NTSC frequency
- sfc/cpu: move 4x8-bit SMP ports to SMP class
- sfc/smp: move APU RAM to DSP class
- sfc/smp: improved emulation of TEST registers bits 4-7 [information
from nocash]
- d4,d5 is RAM wait states (1,2,5,10)
- d6,d7 is ROM/IO wait states (1,2,5,10)
- sfc/smp: code cleanup to new style (order from lowest to highest
bits; use .bit(s) functions)
- sfc/smp: $00f8,$00f9 are P4/P5 auxiliary ports; named the registers
better
byuu says:
Changelog:
- fc/apu: $4003,$4007 writes initialize duty counter to 0 instead of 7
- fc/apu: corrected duty table entries for use with decrementing duty
counter
- processor/spc700: emulated the behavior of cycle 3 of (x)+
instructions to not read I/O registers
- specifically, this prevents reads from $fd-ff from resetting the
timers, as observed on real hardware
- sfc/controller: added ControllerPort class to match Mega Drive
design
- sfc/expansion: added ExpansionPort class to match Mega Drive design
- sfc/system: removed Peripherals class
- sfc/system: changed `colorburst()` to `cpuFrequency()`; added
`apuFrequency()`
- sfc: replaced calls to `system.region == System::Region::*` with
`Region::*()`
- sfc/expansion: remove thread from scheduler when device is destroyed
- sfc/smp: `{read,write}Port` now use a separate 4x8-bit buffer instead
of underlying APU RAM [hex\_usr]
byuu says:
Changelog:
- (u)int(max,ptr) abbreviations removed; use _t suffix now [didn't feel
like they were contributing enough to be worth it]
- cleaned up nall::integer,natural,real functionality
- toInteger, toNatural, toReal for parsing strings to numbers
- fromInteger, fromNatural, fromReal for creating strings from numbers
- (string,Markup::Node,SQL-based-classes)::(integer,natural,real)
left unchanged
- template<typename T> numeral(T value, long padding, char padchar)
-> string for print() formatting
- deduces integer,natural,real based on T ... cast the value if you
want to override
- there still exists binary,octal,hex,pointer for explicit print()
formatting
- lstring -> string_vector [but using lstring = string_vector; is
declared]
- would be nice to remove the using lstring eventually ... but that'd
probably require 10,000 lines of changes >_>
- format -> string_format [no using here; format was too ambiguous]
- using integer = Integer<sizeof(int)*8>; and using natural =
Natural<sizeof(uint)*8>; declared
- for consistency with boolean. These three are meant for creating
zero-initialized values implicitly (various uses)
- R65816::io() -> idle() and SPC700::io() -> idle() [more clear; frees
up struct IO {} io; naming]
- SFC CPU, PPU, SMP use struct IO {} io; over struct (Status,Registers) {}
(status,registers); now
- still some CPU::Status status values ... they didn't really fit into
IO functionality ... will have to think about this more
- SFC CPU, PPU, SMP now use step() exclusively instead of addClocks()
calling into step()
- SFC CPU joypad1_bits, joypad2_bits were unused; killed them
- SFC PPU CGRAM moved into PPU::Screen; since nothing else uses it
- SFC PPU OAM moved into PPU::Object; since nothing else uses it
- the raw uint8[544] array is gone. OAM::read() constructs values from
the OAM::Object[512] table now
- this avoids having to determine how we want to sub-divide the two
OAM memory sections
- this also eliminates the OAM::synchronize() functionality
- probably more I'm forgetting
The FPS fluctuations are driving me insane. This WIP went from 128fps to
137fps. Settled on 133.5fps for the final build. But nothing I changed
should have affected performance at all. This level of fluctuation makes
it damn near impossible to know whether I'm speeding things up or slowing
things down with changes.
byuu says:
Changelog:
- restructured the project and removed a whole bunch of old/dead
directives from higan/GNUmakefile
- huge amounts of work on hiro/cocoa (compiles but ~70% of the
functionality is commented out)
- fixed a masking error in my ARM CPU disassembler [Lioncash]
- SFC: decided to change board cic=(411,413) back to board
region=(ntsc,pal) ... the former was too obtuse
If you rename Boolean (it's a problem with an include from ruby, not
from hiro) and disable all the ruby drivers, you can compile an
OS X binary, but obviously it's not going to do anything.
It's a boring WIP, I just wanted to push out the project structure
change now at the start of this WIP cycle.
byuu says:
Changelog:
- added Cocoa target: higan can now be compiled for OS X Lion
[Cydrak, byuu]
- SNES/accuracy profile hires color blending improvements - fixes
Marvelous text [AWJ]
- fixed a slight bug in SNES/SA-1 VBR support caused by a typo
- added support for multi-pass shaders that can load external textures
(requires OpenGL 3.2+)
- added game library path (used by ananke->Import Game) to
Settings->Advanced
- system profiles, shaders and cheats database can be stored in "all
users" shared folders now (eg /usr/share on Linux)
- all configuration files are in BML format now, instead of XML (much
easier to read and edit this way)
- main window supports drag-and-drop of game folders (but not game files
/ ZIP archives)
- audio buffer clears when entering a modal loop on Windows (prevents
audio repetition with DirectSound driver)
- a substantial amount of code clean-up (probably the biggest
refactoring to date)
One highly desired target for this release was to default to the optimal
drivers instead of the safest drivers, but because AMD drivers don't
seem to like my OpenGL 3.2 driver, I've decided to postpone that. AMD
has too big a market share. Hopefully with v093 officially released, we
can get some public input on what AMD doesn't like.
byuu says:
This will be another massive diff from the previous version.
All of higan was updated to use the new foo& bar syntax, and I also
updated switch statements to be consistent as well (but not in the
disassemblers, was starting to get an RSI just from what I already did.)
phoenix/{windows, cocoa, qt} need to be updated to use "string foo"
instead of "const string& foo", and after that, the major diffs should
be finished.
This archive is the first time I'm posting my copy-on-write,
size+capacity nall::string class, so any feedback on that is welcome as
well.
byuu says:
Basically just a project rename, with s/bsnes/higan and the new icon
from lowkee added in.
It won't compile on Windows because I forgot to update the resource.rc
file, and a path transform command isn't working on Windows.
It was really just meant as a starting point, so that v091 WIPs can flow
starting from .00 with the new name (it overshadows bsnes v091, so
publicly speaking this "shouldn't exist" and will probably be deleted
from Google Code when v092 is ready.)
Tim Allen