bsnes/higan/md/controller/controller.hpp

34 lines
707 B
C++
Raw Normal View History

Update to v101r12 release. byuu says: Changelog: - new md/bus/ module for bus reads/writes - abstracts byte/word accesses wherever possible (everything but RAM; forces all but I/O to word, I/O to byte) - holds the system RAM since that's technically not part of the CPU anyway - added md/controller and md/system/peripherals - added emulation of gamepads - added stub PSG audio output (silent) to cap the framerate at 60fps with audio sync enabled - fixed VSRAM reads for plane vertical scrolling (two bugs here: add instead of sub; interlave plane A/B) - mask nametable read offsets (can't exceed 8192-byte nametables apparently) - emulated VRAM/VSRAM/CRAM reads from VDP data port - fixed sprite width/height size calculations - added partial emulation of 40-tile per scanline limitation (enough to fix Sonic's title screen) - fixed off-by-one sprite range testing - fixed sprite tile indexing - Vblank happens at Y=224 with overscan disabled - unsure what happens when you toggle it between Y=224 and Y=240 ... probably bad things - fixed reading of address register for ADDA, CMPA, SUBA - fixed sign extension for MOVEA effect address reads - updated MOVEM to increment the read addresses (but not writeback) for (aN) mode With all of that out of the way, we finally have Sonic the Hedgehog (fully?) playable. I played to stage 1-2 and through the special stage, at least. EDIT: yeah, we probably need HIRQs for Labyrinth Zone. Not much else works, of course. Most games hang waiting on the Z80, and those that don't (like Altered Beast) are still royally screwed. Tons of features still missing; including all of the Z80/PSG/YM2612. A note on the perihperals this time around: the Mega Drive EXT port is basically identical to the regular controller ports. So unlike with the Famicom and Super Famicom, I'm inheriting the exension port from the controller class.
2016-08-21 22:11:24 +00:00
struct Controller : Thread {
Controller(uint port);
virtual ~Controller();
static auto Enter() -> void;
auto main() -> void;
virtual auto readData() -> uint8 { return 0xff; }
virtual auto writeData(uint8 data) -> void {}
const uint port;
};
Update to v103r02 release. byuu says: Changelog: - fc/apu: improved phase duty cycle emulation (mode 3 is 25% phase inverted; counter decrements) - md/apu: power/reset do not cancel 68K bus requests - md/apu: 68K is not granted bus access on Z80 power/reset - md/controller: replaced System::Peripherals with ControllerPort concept - md/controller: CTRL port is now read-write, maintains value across controller changes (and soon, soft resets) - md/psg: PSG sampling rate unintentionally modified¹ - processor/spc700: improve cycle timing of (indirect),y instructions [Overload] - processor/spc700: idle() cycles actually read from the program counter; much like the 6502 [Overload] - some of the idle() cycles should read from other addresses; this still needs to be supported - processor/spc700: various cleanups to instruction function naming - processor/z80: prefix state (HL→IX,IY override) can now be serialized - icarus: fix install rule for certain platforms (it wasn't buggy on FreeBSD, but was on Linux?) ¹: the clock speed of the PSG is oscillator/15. But I was setting the sampling rate to oscillator/15/16, which was around 223KHz. I am not sure whether the PSG should be outputting at 3MHz or 223KHz. Amazingly ... I don't really hear a difference either way `o_O` I didn't actually mean to make this change; I just noticed it after comparing the diff between r01 and r02. If this turns out to be wrong, set stream = Emulator::audio.createStream(1, frequency() / 16.0); in md/psg.cpp to revert this change.
2017-06-27 01:18:28 +00:00
struct ControllerPort {
auto connect(uint deviceID) -> void;
Update to v103r02 release. byuu says: Changelog: - fc/apu: improved phase duty cycle emulation (mode 3 is 25% phase inverted; counter decrements) - md/apu: power/reset do not cancel 68K bus requests - md/apu: 68K is not granted bus access on Z80 power/reset - md/controller: replaced System::Peripherals with ControllerPort concept - md/controller: CTRL port is now read-write, maintains value across controller changes (and soon, soft resets) - md/psg: PSG sampling rate unintentionally modified¹ - processor/spc700: improve cycle timing of (indirect),y instructions [Overload] - processor/spc700: idle() cycles actually read from the program counter; much like the 6502 [Overload] - some of the idle() cycles should read from other addresses; this still needs to be supported - processor/spc700: various cleanups to instruction function naming - processor/z80: prefix state (HL→IX,IY override) can now be serialized - icarus: fix install rule for certain platforms (it wasn't buggy on FreeBSD, but was on Linux?) ¹: the clock speed of the PSG is oscillator/15. But I was setting the sampling rate to oscillator/15/16, which was around 223KHz. I am not sure whether the PSG should be outputting at 3MHz or 223KHz. Amazingly ... I don't really hear a difference either way `o_O` I didn't actually mean to make this change; I just noticed it after comparing the diff between r01 and r02. If this turns out to be wrong, set stream = Emulator::audio.createStream(1, frequency() / 16.0); in md/psg.cpp to revert this change.
2017-06-27 01:18:28 +00:00
auto readControl() -> uint8;
auto writeControl(uint8 data) -> void;
auto power(uint port) -> void;
auto unload() -> void;
auto serialize(serializer&) -> void;
uint port;
uint8 control;
Controller* device = nullptr;
Update to v103r02 release. byuu says: Changelog: - fc/apu: improved phase duty cycle emulation (mode 3 is 25% phase inverted; counter decrements) - md/apu: power/reset do not cancel 68K bus requests - md/apu: 68K is not granted bus access on Z80 power/reset - md/controller: replaced System::Peripherals with ControllerPort concept - md/controller: CTRL port is now read-write, maintains value across controller changes (and soon, soft resets) - md/psg: PSG sampling rate unintentionally modified¹ - processor/spc700: improve cycle timing of (indirect),y instructions [Overload] - processor/spc700: idle() cycles actually read from the program counter; much like the 6502 [Overload] - some of the idle() cycles should read from other addresses; this still needs to be supported - processor/spc700: various cleanups to instruction function naming - processor/z80: prefix state (HL→IX,IY override) can now be serialized - icarus: fix install rule for certain platforms (it wasn't buggy on FreeBSD, but was on Linux?) ¹: the clock speed of the PSG is oscillator/15. But I was setting the sampling rate to oscillator/15/16, which was around 223KHz. I am not sure whether the PSG should be outputting at 3MHz or 223KHz. Amazingly ... I don't really hear a difference either way `o_O` I didn't actually mean to make this change; I just noticed it after comparing the diff between r01 and r02. If this turns out to be wrong, set stream = Emulator::audio.createStream(1, frequency() / 16.0); in md/psg.cpp to revert this change.
2017-06-27 01:18:28 +00:00
};
extern ControllerPort controllerPort1;
extern ControllerPort controllerPort2;
extern ControllerPort extensionPort;
Update to v101r12 release. byuu says: Changelog: - new md/bus/ module for bus reads/writes - abstracts byte/word accesses wherever possible (everything but RAM; forces all but I/O to word, I/O to byte) - holds the system RAM since that's technically not part of the CPU anyway - added md/controller and md/system/peripherals - added emulation of gamepads - added stub PSG audio output (silent) to cap the framerate at 60fps with audio sync enabled - fixed VSRAM reads for plane vertical scrolling (two bugs here: add instead of sub; interlave plane A/B) - mask nametable read offsets (can't exceed 8192-byte nametables apparently) - emulated VRAM/VSRAM/CRAM reads from VDP data port - fixed sprite width/height size calculations - added partial emulation of 40-tile per scanline limitation (enough to fix Sonic's title screen) - fixed off-by-one sprite range testing - fixed sprite tile indexing - Vblank happens at Y=224 with overscan disabled - unsure what happens when you toggle it between Y=224 and Y=240 ... probably bad things - fixed reading of address register for ADDA, CMPA, SUBA - fixed sign extension for MOVEA effect address reads - updated MOVEM to increment the read addresses (but not writeback) for (aN) mode With all of that out of the way, we finally have Sonic the Hedgehog (fully?) playable. I played to stage 1-2 and through the special stage, at least. EDIT: yeah, we probably need HIRQs for Labyrinth Zone. Not much else works, of course. Most games hang waiting on the Z80, and those that don't (like Altered Beast) are still royally screwed. Tons of features still missing; including all of the Z80/PSG/YM2612. A note on the perihperals this time around: the Mega Drive EXT port is basically identical to the regular controller ports. So unlike with the Famicom and Super Famicom, I'm inheriting the exension port from the controller class.
2016-08-21 22:11:24 +00:00
#include "gamepad/gamepad.hpp"